Today’s alarm systems depend on batteries as part of your. The home self-protection system has always had a back battery for the control panel. These batteries would furnish power in case your home experienced an electric loss. In this event the self-protection system would still function for a time and continue to provide protection for your home.
With today’s wireless alarm systems the battery is even more critical than previously. Every wireless device is powered by a battery. If your wireless device has a battery that is weak the machine will generate a trouble that will alert you türsprechanlage of the problem and where the problem exists. This is another reason to have an accurate zone list for your self-protection system. The last thing you want is to be chasing a low battery signal and not be able to replace the correct battery.
Your home security system is often operating on house current or AC. The backup battery is checked by the control panel for the proper operating voltage. If the voltage goes below a base level then the control panel will generate a system battery trouble. If the AC to your control panel is lost a different trouble will be generated that will indicate AC loss.
There is no exact opinion of how long your system battery lasts. It depends on the A/H Amp Hour rating of your battery and the total current draw of your alarm panel. This is typically based on the number of devices linked to your system. Typically without an alarm condition your self-protection system will easily operate for a 24 hour period. If your self-protection system is triggered while using your battery backup the backup period will be much less. If your system remains in battery backup mode for an extended period of time and your battery goes dead it is best to replace the machine battery. When you have a new self-protection system battery the warranty is typically for one year.
There is a wide variety of batteries utilised in wireless alarm systems. They range from your standard double batteries to 9 volt. The newer wireless devices use a much smaller battery such as a lithium 3v battery. These batteries allow for a much thinner device which combinations in well with your home. How long that your devices lasts depends on how the device is used. Your wireless devices are in stand by a lot of the time to conserve the batteries but they are always ready to perform when they are asked to do so. A good estimate of time would be approximately 12 months. A good rule of thumb is to replace your batteries once a year. This can be expensive depending on the size of your system. You can wait prior to the devices report a low battery condition. If you start to see a number of devices that are canceling low battery it is best to simply replace all of the device batteries or to begin with make sure to purchase all of the batteries that you would desire. By purchasing a larger amount you can save money and you know you will eventually need them.
Every self-protection system that is installed has a statement in your owner manual that says that you should test your self-protection system monthly. It is your responsibility to ensure that your system is functioning properly. You must inspect what you expect. In years of providing self-protection system I have never found anyone that tests their self-protection system as often as they should. Once per month may be a bit of overkill but never should not be an option. If you are replacing your battery as a result of low battery condition then the trouble should go away alone. Some systems will take a period of time for this to occur because the control panel does not test for battery voltage continuously. If you want the difficulty to clear right away you will need to unplug the battery and eliminate the power from the panel. Always plug the battery in first and then restore system power. The difficulty should be clear as the system powers back up.
You should test your system on battery at least some of the time. In order to test your system with the battery backup you will need to detach system power. Then arm your system and set it into alarm. Allow the system to ring the alarm siren until it cuts off automatically. Then you can disarm your system. Make sure that you inform your alarm monitoring company before you test your system. If the control panel does perform adequately during testing then you might want to replace your alarm battery.